Gw-instek PPH-1503 User Manual download pdf (Page 51)

BASIC OPERATION

Timeout

 Pulse timeout

 When long integration measurement is

selected and the unit doesn’t detect a

pulse after a certain amount of time

(pulse timeout time), the “No Pulse”

message will be displayed on the LCD.

This function is only applicable if rising

or falling edge is selected as the edge

trigger; the Trig On Neither trigger

setting has no pulse timeout. The pulse

timeout has a range of 1~63 seconds.

TrigLeve[4]

 Trigger level.

 When the rising or falling edge trigger is

selected for long integration current

measurement, a pulse must first be

detected. The trigger level refers to

minimum pulse level required for a

pulse to be detected. For example if the

trigger level is set to 2A, pulses that are

≤2A will be detected. Pulses <2A will be

ignored. The trigger level range is 0~5A.

This setting only applies to long current

integration measurements.

RecallSetup

Recalls pre-saved setups. A total of 6

setups can be recalled: RST/SAV0 ~

SAV4. See page 60 for details.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 136 137

No comments

Gw-instek PPH-1503 User Manual Page 51