Gw-instek GOS-6103C User Manual download pdf (Page 26)

GOS-6103C OSCILLOSCOPE

USER MANUAL

 47 

Figure 5-12(a) TV-V Figure 5-12(b) TV-H

The polarity of the synchronization pulse is critical for the slope selection.

The figure 5-13(a) and 5-13(b) shows the examples of TV polarity

synchronization signals.

Figure 5-13(a) ( ) Sync signal. Figure 5-13(b) ( ) Sync signal

GOS-6103C OSCILLOSCOPE

USER MANUAL

 48 

5-6.Measurement Application

The oscilloscope has a cursor measurement system for making accurate,

direct-readout voltage, time, frequency and phase measurements. The

measurements described in this section are examples of typical

applications using this measurement system. After becoming familiar

with the controls, indicators, and capabilities of the instrument, you can

develop convenient methods to make the special measurement for your

own applications.

Proceed a measurement by using the cursor according to the following

steps:

1. Pressing and holding the CURSOR FUNCTION-ON/OFF pushbutton

to turn on the cursor and measurement readout.

2. Briefly pressing the pushbutton to select the seven measurement

function in the sequence as below:

△ V —△V% —△VdB —△T —△T% —1/△T —△Θ —△V

3. If the associated indicator CURSOR POS-LED is lighted, rotate the

C1-POSITION control to position the cursor 1 and rotate the

C2-POSITION control to position the cursor 2.

4. Read the measurement value on the screen. Typical measurement

readouts and applications are shown in Figure 5-14. The measurement

values are automatically controlled by the VOLTS/DIV and TIME/DIV

control settings.

1 2 ... 21 22 23 24 25 26 27 28 29 30

No comments

Gw-instek GOS-6103C User Manual Page 26