Gw-instek GOS-6103C User Manual download pdf (Page 16)

GOS-6103C OSCILLOSCOPE

USER MANUAL

 27 

Measurement and Panel setting Control

The measurement section controls the on-screen readout and the cursor

measurements. For more information, please refer to page 9 “PANEL

INTRODUCTION” section for the instrument to store and recall the

panel setting.

(33) MEAS’MT FUNC—AUTO/CURSOR—Pushbutton with two functions.

AUTO/CURSOR

Pressing and holding the pushbutton to select measurement function

between AUTO and CURSOR measurement mode.

In the AUTO measurement mode, the built-in 6 digit universal counter is

accurate within a range of ±0.01% and can measure frequencies between

50Hz and 100MHz.

In the CURSOR measurement mode, the cursor lines are part of the

readout, they are visible only when the readout is switched on.

GOS-6103C OSCILLOSCOPE

USER MANUAL

 28 

FUNC (Function)

In the AUTO measurement mode, each time when the pushbutton is

briefly pressed the four measurement parameters will be selected in the

sequence as follows:

FREQ PERIOD ±WIDTH ±DUTY OFF

In the CURSOR measurement mode, each time when the pushbutton is

briefly pressed the seven measurement functions will be selected in the

sequence as follows:

△V : Voltage difference measurement.

△V% : Voltage difference percentage measurement

(5div=100% reference)

△VdB : Voltage gain measurement.

(5div=0dB reference, △VdB=20 log △V div/5div).

△T : Time difference measurement.

△T% : Time difference percentage measurement.

(5div=100% reference).

1/△T : Frequency measurement.

△θ : Phase measurement.

(5div=360

reference).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

No comments

Gw-instek GOS-6103C User Manual Page 16