Gw-instek AFG-2225 User Manual User Manual download pdf (Page 250)

AFG-2225 Series User Manual

250

The following is an overview of the steps required to generate a

burst waveform.

Enable Burst

Mode

Configuration

Choose

Triggered/Gated

Mode

Set Burst Count

Set the burst

period

Set Burst Starting

Phase

Select the trigger

1. Turn on Burst mode using the

SOURce[1|2]:BURS:STAT ON command.

2. Use the APPLy command to select a sine,

square, ramp, pulse burst waveform*.

Alternatively, the FUNC, FREQ, AMPl, and

DCOffs commands can be used to create the

burst waveform* with a designated frequency,

amplitude and offset.

*2 mHz minimum for internally triggered

bursts.

3. Use the SOURce[1|2]: BURS:MODE

command to select from triggered or gated

burst modes.

4. Use the SOURce[1|2]:BURS:NCYC command

to set the burst count. This command is only

for triggered burst mode only.

5. Use the SOURce[1|2]:BURS:INT:PER

command to set the burst period/cycle. This

command is only applicable for triggered

burst mode (internal trigger).

6. Use the SOURce[1|2]:BURS:PHAS command

to set the burst starting phase.

7. Use the SOURce[1|2]:BURS:TRIG:SOUR

command to select the trigger source for

triggered burst mode only.

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 300 301

No comments

Gw-instek AFG-2225 User Manual User Manual Page 250