
REMOTE INTERFACE
111
Sets or disables AM modulation. By default AM
modulation is disabled. AM modulation must be
enabled before setting other parameters.
As only one mode is allowed at any one time,
other modulation modes (inc. Sweep/FSK) will be
disabled when AM modulation is enabled.
SOURce[1]:AM:STATe {OFF|ON}
AM modulation mode is currently enabled.
Sets or queries the modulation source as internal
or external. Internal is the default modulation
source.
If an external modulation source is selected,
modulation depth is limited to ± 5V from the MOD
input port on the rear panel. For example, if
modulation depth is set to 100%, then the
maximum amplitude is +5V, and the minimum
amplitude is -5V.
SOURce[1]:AM:SOURce {INTernal|EXTernal}
Sets the modulation source to external.
Comments to this Manuals