Gw-instek GOS-652G User Manual download pdf (Page 10)

⎯ 5 ⎯

20MHz OSCILLOSCOPE 35MHz 50MHz OSCILLOSCOPEMODEL

SPECIFICATIONS

622G

626G 623G 635G 652G 653G 658G

Waveform Positive-going square wave

Frequency

1 kHz ±5%

Duty ratio Within 48:52

Output voltage

2 Vp-p ±2%

CALIBRATION

VOLTAGE

Output impedance Approx. 2 k ohm.

Type 6-inch rectangular type, internal graticule.

Phosphor P 31

Acceleration voltage Approx. 2 kV Approx. 12 kV

Effective screen size

8 × 10 DIV ( 1 DIV = 10mm(0.39in))

CRT

Graticule Internal;

continuous adjustable illumination (623G,626G,652G,653G,658G only)

Cursor measurement functions

△V ,△V% ,△VdB, △T ,1/△T ,DUTY ,PHASE

Cursor display format

▽(DELTA), ▼(REF)

Cursor resolution 1/25 DIV

Effective cursor range from center

graticule

Vertical: ±3 DIV

Horizontal: ±4 DIV

CURSOR

READOUT

(626G,658G)

Panel setting display

V/DIV,V-MODE, INV, ALT/CHOP, UNCAL, ADD(SUB), ×10MAG,

PROBE(×1/×10), X-Y, A T/D, TV-V/H,

B T/D(for 658G only)

Measurement category I is for measurements performed on circuits not directly connected to MAINS.

Measurement category II is for measurements performed on circuits directly connected to the low voltage installation.

Measurement category III is for measurements performed in the building installation.

Measurement category IV is for measurements performed at the source of the low-voltage installation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Gw-instek GOS-652G User Manual Page 10