Gw-instek GPI-700A Series User Manual User Manual

Electrical Safety Tester GPT/GPI-700A Series USER MANUAL GW INSTEK PART NO. 82PI-74500MG1 ISO-9001 CERTIFIED MANUFACTURER

ELECTRICAL SAFETY TESTER USER MANUAL 11 Secure Testing Never operate the tester in the place with electric circuit device around. The earth lead

ELECTRICAL SAFETY TESTER USER MANUAL 13 4-2. Rear Panel ELECTRICAL SAFETY TESTER USER MANUAL 14 1 Model Number Model number and descriptio

ELECTRICAL SAFETY TESTER USER MANUAL 15 19 SOURCE+ Terminal(only for Ground Bond Test) High current terminal for Ground Bond test. 20 Power Swit

ELECTRICAL SAFETY TESTER USER MANUAL 17 Output voltage or current for each step A C : Output voltage (0.100~ 5.000 kV) D C : Output voltage (0.10

ELECTRICAL SAFETY TESTER USER MANUAL 19 5-2. Prepare the EST for Use z To view the Storage Steps 1. Press the MENU key to enter status MENU.

ELECTRICAL SAFETY TESTER USER MANUAL 21 4. Use FIELD key to change active parameter. 5. Repeat step 3 and 4 to adjust parameter. 6. Af

ELECTRICAL SAFETY TESTER USER MANUAL 23 5. If you press RESET button the test will stop immediately. 6. If the result is pass, the PASS

ELECTRICAL SAFETY TESTER USER MANUAL 25 z To View the System Utility 1. Press the UTILITY key to enter status UTIL. 2. Use the knob or a

ELECTRICAL SAFETY TESTER USER MANUAL 27 Stop The operation will stop upon the failure occurred at any step of the group tests. Max off Holding m

ELECTRICAL SAFETY TESTER USER MANUAL 29 5-3. Structure of storage steps The storage steps of EST are total 10 groups (group 0 ~ group 9), 16 steps

ELECTRICAL SAFETY TESTER USER MANUAL i WARNING MANUFACTURER ASSUMES NO LIABILITY IF UNIT OPERATED IN AN UNSAFE MANNERWARNING THIS INSTRUME

ELECTRICAL SAFETY TESTER USER MANUAL 31 5-4. Menu parameter setup z AC/DC withstanding voltage test (ACW, DCW— only for GPT-715A /GPI-735A/745A) P

ELECTRICAL SAFETY TESTER USER MANUAL 33 z Continuous AC/DC withstanding voltage test (CAC for all models, CDC-only for GPT-715A/GPI-735A/745A) Th

ELECTRICAL SAFETY TESTER USER MANUAL 35 z Ground Bonding Test (GB- only for GPI-745A) Press MENU key to enter status MENU then use knob and arrow

ELECTRICAL SAFETY TESTER USER MANUAL 37 z Continuity Check (Cnt) Press MENU key to enter status MENU then use knob and arrow keys to select a ste

ELECTRICAL SAFETY TESTER USER MANUAL 39 The function key of front panel can not be used when any two pins of the Reset、Start or C

ELECTRICAL SAFETY TESTER USER MANUAL iii CONTENTS PAGE 1. PRODUCT INTRODUCTION...1-1.Description………………

ELECTRICAL SAFETY TESTER USER MANUAL v FOR UNITED KINGDOM ONLY NOTE: This lead/appliance must only be wired by competent persons. WARNING: THIS

ELECTRICAL SAFETY TESTER USER MANUAL 1 1. PRODUCT INTRODUCTION 1-1. Description The GPT/GPI-700A series Electrical Safety Testers (EST) are desig

ELECTRICAL SAFETY TESTER USER MANUAL 3 10) Flashing high voltage indicator A flashing red LED indicates dangerous situation during high voltage ou

ELECTRICAL SAFETY TESTER USER MANUAL 5 3) Insulation Resistance Specifications (for GPI-725A/ 735A/ 745A only) DC Voltage 50V/100V/500V/1000V Res

ELECTRICAL SAFETY TESTER USER MANUAL 7 13) General Power Source AC100V, 120V, 220V, 230V±10% 50/60HzOperation Environment Indoor use, altitude up

ELECTRICAL SAFETY TESTER USER MANUAL 9 3. PRECAUTIONS BEFORE OPERATION 3-1. Unpacking the instrument The product has been fully inspected and test